Cleaning And Care - Springlane Hanno Manual De Instrucciones

Cleaning and care

The container should be cleaned and dried
as follows after each use. Not (properly)
cleaning the high-performance mixer
might impair its functionality.
1. Clean the container by filling it with
800 ml of warm water and a few
drops of a mild dish soap. Close the
container with the lid and set the
controller to "Clean." The program will
start automatically and run as follows:
1 minute, 9 times in the pulse function
and then it will continue operating at
medium speed. Remove the container
from the motor block and then rinse it
out. Repeat the process, if required.
2. Before cleaning, switch off the device
and disconnect the plug from the
connector.
3. Never dunk the housing of the motor
base into water.
4. Do not use scratching or abrasive
cleaning agents.
5. Only wipe off the housing with a moist
cloth.
6. Do not attempt to remove the cutting
blades from the mixer container in
order to clean them. This might cause
the mixer container to leak.
7. Remove the container from the
motor base and remove any remaining
foodstuffs from the container. Pay
attention to not injure yourself on the
blades when cleaning.
8. Clean removable plastic parts on the
top shelf of a dishwasher and use a
programme with at most 60 °C to
keep them from losing their shape.
Make sure that the plastic part is not
jammed.
9. Allow the container and individual
parts to dry properly before
reassembling.
27