Dräger FPS 7000 Instrucciones De Uso página 6

7 Use
CAUTION
!
If a full face mask with assembled holder without a
communication system is to be used, place the protective
cap on the holder. Otherwise there is risk of injury.
1. Ensure that the battery of the radio is fully charged.
2. Connect the cable of the COM control unit to the radio.
3. Fasten the full face mask.
4. Turn on the radio.
5. Check the radio connection. Press the PTT button to do so.
6. Adjust the volume of the earpiece using the volume regulator
of the radio. Dräger recommends marking the position of the
volume regulator on the radio.
7. When using the COM control belt clip, make sure that the COM
control unit is attached in such a manner that the PTT button
can be easily operated.
If Velcro is used, attach the COM control unit to the radio and
put the radio in the radio pocket.
8 Cleaning
1. In order to avoid injuries, remove the communication system
from the full face mask and place the protective cap on the
holder.
CAUTION
!
Do not use solvents such as acetone, alcohol, etc. for
cleaning the communication system.
Clean the communication system carefully to avoid
damaging the microphone or earpiece.
2. Clean the communication system with a damp sponge or a
brush and water with all-purpose cleaner.
3. Clean the plug-in connections with high-quality Vaseline spray
or a similar lubricant.
9 Storage
Storage temperature: -15 °C to +25 °C
Store protected against direct sunlight and heat.
6