Cleaning And Care; Troubleshooting - Orbegozo AP 4500 Manual De Instrucciones

AP 4500
2. There are two different powers: Push the power button once for minimum power and push it again
for maximum power.
3. Push the power button once again and the unit will turn off

CLEANING AND CARE

In order to achieve the best performance, empty the dust cup container and clean the dust cup filter after
each use.
1. Turn off the vacuum cleaner and remove the charging cable.
2. Hold the vacuum over the bin or bin bag. With one hand holding the handle, unclip the dust cup
cover to open.
3. The dust cup cover will pop open and the dust and debris will empty into the bin.
4. To remove the filters, turn the filter handle anti-clockwise.
5. Remove the inner filter from the outer filter and rinse both in warm water and then let air dry for 24
hours before re-assembling.
6. Ensure you remove all dust and debris from both filters. A soft bristled brush can be used to remove
any blocked dirt from the outer filter.
7. Re-assemble when completely dry.

TROUBLESHOOTING

PROBLEM
Vacuum will not work
Vacuum will not pick-up or
suction power is weak
Dust is escaping from the
vacuum
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that
old household electrical appliances must not be disposed of in the normal unsorted municipal waste
stream. Old appliances must be collected separately in order to optimize the recovery and recycling of
the materials they contain, and reduce the impact on human health and the environment. The crossed
out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the
appliance, it must be separately collected. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage Directive
2014/35/EU and the requirements of the EMC directive 2014/30/EU.
POSSIBLE SOLUTION
The vacuum may have run out of charge. Charge fully.
The dust cup container may be full, or the filters may
require cleaning. Empty the dust cup container and
clean the filters.
The filter may not be installed correctly, or the dust
cup container may be full. Empty the dust container
and reassemble the filter system.
11