Frequency Measurement Using; Current Input - AEMC Instruments 502 Manual De Instrucciones

4.6 Frequency Measurement Using

Current Input

NOTE: Remove the test leads before measuring current
• Turn the rotary range switch to the
• Press the lever to open the jaws.
• Clamp the jaws around the conductor to be mea-
sured.
WARNING: Do not use both voltage and cur-
rent inputs at the same time when measuring
frequency. This may be dangerous. Errone-
ous readings will occur if both inputs are used
at the same time.
TRMS Clamp-on Meter Model 502
range.
15