Filling The Boiler With Water - Euroflex AIRFLUX IB 10 VAPOR Manual De Instrucciones

- Insert the iron cord support (8) in the opening of the steam generator and hang the mono-tube (12).
The iron cord support prevent the unwanted movement of the garments as well as the "wear" of the
mono-tube.

2. Filling the boiler with water

- Pull the plug out of the socket.
- Carefully unscrew the safety cap (1), making sure the steam has completed exhausted.
- Fill the bottle (16).
- Insert the bottle into the opening of the steam generator.
- Thoroughly screw the safety cap back without tightening it too much (tighten too much is useless and
may cause the wear of the seal).
tap water
Important: the maximum capacity of the steam generator is 1.2 liter. Do not forget that some water
always remains inside the generator. When you fill in the water, the air bubbles inside the filling opening
of the steam generator may impede another refilling. We recommend to gently shake the bottle during
the refilling. Never fill the steam generator under water tap: danger of short-circuit!
22
gently push