Freqently Asked Questions - Marmitek KR22E Manual De Instrucciones

back the new setting, e.g. 3 blinks for House Code C. If you do not follow this pro-
gramming sequence, the LED will stay on for 1 second and your existing setting will
not be changed.
To change the Unit Code
To program a new Unit Code, you will need to program the Unit Code on the top right
key marked OFF. The other buttons will then automatically numbered 1 # higher than
the key direct above (e.g. when the first key is set to Unit Code 6, the 2nd will be Unit
Code 7).
1. Press and hold the top OFF button. The red LED blinks once. 3 seconds later, the LED
blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16.
2. Release the top OFF button.
3. Press and release the top OFF key the appropriate number of times for the Unit Code
you want. IMPORTANT: Hold the key on your last press: 3 seconds later the new code
blinks back. If you do not follow this programming sequence, the LED will stay on for 1
second and your existing setting will not be changed.
To change the batteries
Remove the back lid of the remote. Exchange the batteries (3V lithium) of the same type
(KR22E: 2 x type CR2016). Observe the polarity.

FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your neighbours using
the same House Code. To solve this problem try to change the House Code of your sys-
tem, or have FD10 Phase Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are set to the same
House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or
Marmitek Security Console installed in your house. These components will translate the
radio signals to the Marmitek X-10 signal on the power line. Only one Transceiver should
be installed for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your
remotes is not sufficient. The TM13 is using so called collision detection to prevent sig-
nals to be disturbed when more than one TM13 is transmitting. TM13's will wait for a
6 © MARMITEK