Control Panel Display On/Off Function (Remote Control Only); Memory Shortcut Function (Remote Control Only); Swing Operation; Drainage - Proline PAC8K Manual De Instrucciones

Control panel display ON/OFF function (remote control only)

If you prefer to switch off the control panel display, press
To switch on the control panel display, press

Memory shortcut function (remote control only)

 This function is used to restore the current settings or restore previous settings.
 Pressing this button
the previous settings including operating mode, set temperature, fan speed level and sleep mode (if
activated).
 If pressing
for more than 2 seconds, the system will automatically restore the current operation
settings including operating mode, set temperature, fan speed level and sleep mode (if activated).

Swing operation

Move the horizontal louvres directly to adjust the air flow direction.

DRAINAGE

When the internal water tank is full, the display will show "P1".
To empty the water tank do the following:
1. Switch off the appliance and remove the plug from the mains socket.
2. Place a water tray (not supplied) on the floor underneath the bottom drainage point.
3. Remove the drain cap and rubber plug from the drain and let the water run out.
4. Replace the rubber plug and drain cap, plug the appliance into the mains socket, and switch the
appliance on.
 "P1" will disappear on the display.
whilst the remote control is on, the system will automatically revert back to
.
again.
13