Troubleshooting; Technical Data - Proline PAC8K Manual De Instrucciones

TROUBLESHOOTING

Never try to repair or dismantle the air conditioner yourself.
Problem
The air conditioner does
not function.
The air conditioner
seems to have little
cooling effect.
The air conditioner is
noisy.
Error codes
Display
E1 The room temperature sensor has failed.
E2 The evaporator temperature sensor has
failed.
E4 The display panel communication has failed.

TECHNICAL DATA

Rated capacity for cooling (P
Rated power input for cooling (P
Rated Energy efficiency ratio (EER
Rated Energy efficiency ratio (COPd)
Power consumption in thermostat-off mode (P
Power consumption in standby mode (P
Electricity consumption of single duct appliances (Q
Sound power level (L
WA
Global warming potential (GWP)
Energy class
+++ +++
(A ......D, A =economical D=less economical)
Cooling capacity
Excessive operating pressure
Weight
Power source
Possible Cause
No power supply.
"P1" is shown on the display.
The room temperature is lower than the
selected temperature.
In direct sunlight.
Windows or doors open, many people
or a heat source in the room.
Dirty filter.
Air inlet or air outlet blocked.
The room temperature is lower than the
selected temperature.
The appliance stands uneven.
Cause
for cooling)
rated
)
EER
)
rated
)
SB
)
Unplug the appliance and plug it back in. If
error repeats, call for service.
2.3kW
1100W
2.6
NA
) NA
TO
0.452 W
) 0.9 kWh/h
SD
65 dB (A)
2088 kgCO
2
A
8000 Btu/h
DISCHARGE: 4.2MPa
SUCTION:
23.5kg
220-240V~ 50Hz, 1Ph
15
Possible Solution
Connect to a functioning outlet
and switch on.
Empty the internal water tank.
Change temperature selection.
Close curtains.
Close doors and windows,
remove the heat sources, and
place an extra air conditioner.
Clean the filter.
Remove the blockage.
Change temperature selection.
Place the appliance on an even,
solid surface (less vibrations).
Solution
eq.
1.5MPa