General Characteristics - Dea 220H Instrucciones De Uso

5 USER MANUAL
1 Description
This receiver has been developed for recessed installation into wall outlets and permits the control of devices from remote or local (e.g.
via a control panel or standard wall-recessed switches) through two relay output channels. It is powered directly from the 110/230 V
mains. For remote operation, you can use any DEA remote control operating at 433,92 MHz, FIX or ROLLING code.

1.1 General Characteristics

• Power supply: 110/230Vac 50/60Hz;
• Operating frequency: 433,92 MHz;
• 2 relay outputs:
- 5A / 250V (1250W) Static load (Lighting);
- 2A / 250V (500W) Reactive load (Motor);
• 2 local inputs;
• 4 output control modes:
- monostable;
- bistable (factory default);
- timed;
- motor control;
• Key for learning / configuration;
• Led + buzzer during learning / configuration;
• Up to 30 acquirable remote controls, intended as an individual key (the number depends on the type of code used; if a remote control
has several keys, each key must be considered as a remote control).
1.2 I/O terminal board
Description of I/O terminal board connections:
• Terminal 1: input 1, for local control of output 1;
• Terminal 2: input 2, for local control of output 2;
• Terminal 3: power supply input (line/positive);
• Terminal 4: power supply input (neutral/negative);
• Terminal 5: relays common;
• Terminal 6: N.O. output 1;
• Terminal 7: N.O. output 2;
2 Operation
2.1 Operation with remote input (remote control)
1. Switching on the device
2. When you turn on it, the device emits:
- One LED flash, accompanied by one low tone of ½ second if there is at least one remote stored
- Two LED flashes accompanied by two low tones if there are no remote controls stored.
3. The reciever can receive fixed code remote controls (HT12) and HCS. Each radio button is memorised individually, using the program-
ming procedure to associate the function desired by the user (See Tab. 1).
OPERATION OF TRANSMITTER IN
"LIGHT CONTROL" MODE
N° of Operating mode
1.1
1.2
1.3
16
Operation
Monostable
Bistable
Timed
Table 1
OPERATION OF TRANSMITTER IN
"MOTOR CONTROL" MODE
N° of Operating mode
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
Operation
Stepped
Ascent/stop
Descent/ stop
Deadman stepped
Deadman ascent
Deadman descent
Stop
Ascent
Descent