Mode Selection - Dea 220H Instrucciones De Uso

3 Single Remote Control Erasure
Description
Phase
Press and hold the programming button of the MINI-RX until the LED on the receiver performs a
1
blink and the buzzer performs an acoustic warning.
After about 1 second by the release of the button, the LED on the receiver emits five flashes.
2
Press the button of the receiver during the 5th flash.
3
4 Push the button on the remote control you want to erase.
5 If cancellation is successful the receiver will emit 5 short flashes and 5 acoustic warnings.
6 To erase another transmitter, repeat step 4
7 To complete the procedure to wait for the 10 seconds time-out
8 End

4 Mode Selection

WARNING Remotes in memory will be deleted.
Phase Description
Press and hold the programming button of the MINI-RX until the LED on the receiver performs a
blink and the buzzer performs an acoustic warning.
1
Hold down the programming button of the MINI-RX for more than 3 seconds. The LED on the
receiver will perform another blink and the buzzer another acoustic warning.
Press the programming button a number of times equal to the mode you want to program:
1 pressure -> Light Control Mode (1 blink and 1 acoustic warning)
2 pressure -> Motor Control Modes (2 blinks and 2 acoustic warnings)
2
3 pressures -> Roll back to Light Control Mode (1 blink and 1 acoustic warning)
The system will notify the user the selection just made through the LED, with a number of blink
(fast) and acoustic warnings equal to the selected function, repeated every 2 seconds
To end the selection, press and hold the programming button.
3
The LED on the receiver performs a blink and the buzzer performs an acoustic warning.
4 End
20
Example
Example