Dea 220H Instrucciones De Uso página 25

7 RADIO PROCEDURES
1 Learning the First Remote Control or Additional Remotes in Light Control Mode
Description
Phase
Press 2 times shortly the programming button of the MINI-RX. The LED on the receiver will per-
1
form 2 blinks and the buzzer will perform two beep every 2 seconds.
Hold down the programming button of the MINI-RX for more than 3 seconds. The LED on the
2
receiver will perform another blink and the buzzer another acoustic warning.
Press the programming button a number of times equal to the output you want to program:
1 pressure -> output 1 (1 blink and 1 acoustic warning)
2 pressures -> output 2 (2 blinks and 2 acoustic warnings)
3
3 pressures -> roll back to output 1 (1 blink and 1 acoustic warning)
The system will notify the user the selection just made with a number of LED blinks (fast), and
acoustic warnings equal to the selected output, repeated every 2 seconds.
Press the button on the remote that you want to store.
4
After saving the receiver will perform two long blinks of the LED and 2 long beeps of the buzzer.
5 To learn another remote control (or another button), repeat step 3.
To complete the learning of a remote control, wait for the programming timeout that will be
6
indicated by a long beep and a long blink of the LED.
NOTE: if the memory is full or whenever the remote control is already present in the memory,
the receiver will perform 10 blinks and 10 acoustic warnings.
7 End
Example
23