Quick Programming Guide - Fermax 4545 Manual De Instalador Y Usuario

TELEPHONE INTERFACE

QUICK PROGRAMMING GUIDE

Option
0 + VDS address (001…199) [1]
+
# # #
0
1 + PIN (0000…9999) [0000]
1
2
3 + Telephone numbers directory in Single Call (SCM) and Multiple Call (MCM)
3
4 + Timing.
4
5
6 6 + Ring tone cadence (1..9)’’ [3]
7
7
8
8
9 + Main panel audio adjustments Input Audio (+3,-6) Output audio (+1,-4)
9
#
#
NOTE:
- To enter programming pick up the telephone and before 3 seconds pass, press # # #, confirming
access to programming mode via a confirmation tone: beep-beep-beep, indicating you are in the
main menu.
- You will also hear this upon completing an option and returning to the main menu.
- The possible range of values to enter are displayed between parenthesis ( ) .
- The default values are displayed between brackets [ ] .
- If the code is correct, a confirmation tone sounds (beep-beep) and if incorrect (beep-bop).
- (Telephone no.) If the forwarded calls come from a switchboard, you must add a '0' and the pauses
(pressing # for each second), before the telephone number.
- Resetting all parameters: When in programming press *000#.
Page 32
Function
No function
1 + (Telephone no.) +
0 0 1
2 + (Telephone no.) +
0 2
0
199 + (Telephone no.) +
9 9
1
Exit submenu 3.
#
#
1 Call duration (01..99)’’ [30]
+
1
2 + Lock-release activation time (01..99)’’ [04]
2
3 Conversation time (01..99)’’ [90]
+
3
4 Forward delay time (01..99)’’ [1]
+
4
5 Auxiliary relay time (00..99)’’ [08]
+
5
# Exit submenu 4.
#
No function.
Forward activation.
Forward deactivation.
Exit the main menu.
Note: In SCM positions (001 and
*
002) are the forwarded telephones.
*
In MCM positions (001 to 199,)
without forwarding activated are
the telephone numbers, and with
forward activated it will dial the
*
number indicated in the position
configured as '0' in the main menu.