Description Of The Parts - Chicco KEYFIT BASE Instrucciones De Uso

check that the different parts of the
child car seat are not too hot: in such
an event, let the child car seat cool
down first before placing the child
into it, in order to avoid burns.
• Artsana declines all responsibility in
cases of incorrect use of this prod-
uct.
WARNING: PLEASE READ THE USER
MANUAL SUPPLIED WITH THE
KEYFIT PRODUCT (Code 79064)
FOR FURTHER INFORMATION ON
HOW TO USE THE CHILD CAR SEAT
CORRECTLY.

DESCRIPTION OF THE PARTS

A Correct reclining indicator
B Lap seat belt through slot
C Instruction booklet compartment
D Reclining adjuster foot
E Rollover protection hoop
F Reclining adjustment buttons
INSTALLATION AND REMOVAL OF
THE BASE
WARNING: ASSEMBLE THE ROLLO-
VER PROTECTION HOOP TO THE
KEYFIT BASE BY SLOTTING IT INTO
THE RELATIVE HOLES (DIAG. 1). PULL
THE HOOP IN ALL DIRECTIONS TO
ENSURE IT IS FIRMLY FITTED IN
PLACE.
Installation
1. Position the base on the chosen vehi-
cle seat, position it so that it touches
the vehicle seat backrest (Diag. 2).
2. Adjust the reclining position of the
base by pressing the two buttons
at the same time (F). The adjuster
foot (D) can be used to fine-tune the
reclining angle even further (Diag. 3).
Check that the indicator (A) bubble is
in a central position to confirm cor-
rect installation.
3. Pull the vehicle safety belt, thread
the lap belt through the two slots
highlighted in blue, and push it into
its relative buckle (Diag.4).
4. Attach the child car seat onto the
base (in a rear-facing position) and
push it downwards until you hear it
click into place (Diag. 5).
5. Check that the child car seat is cor-
rectly fitted to the base by trying
to lift the front and rear sections
(Diag.6).
6. Pull the diagonal car safety belt and
thread it through the relative slot,
highlighted in blue, on the back of
the child car seat backrest (Diag. 7)
7. Pull the belt as tight as possible
around the child car seat, without
leaving any slack and making sure it
is not twisted (Diag.8).
WARNING: NEVER FIT THE CAR
SAFETY BELT IN ANY POSITION
OTHER THAN THOSE INDICATED
IN THE DIAGRAM.
To remove the child car seat from
the base:
Free the diagonal safety belt from the
slot on the backrest, release the child car
seat by pulling the relative lever whilst
using the handgrip to lift it upwards.
WARNING! After installing the child
car seat, ALWAYS check that the car
safety belt is tightened properly, the
buckle clasp does not force the belt
out of the belt slots on the base and
it does not interfere with the belt slots
themselves.
11