Common Interface - Fracarro SIG7531 Instrucciones De Uso

5.3.8 COMMON INTERFACE MENU (ONLY FOR SIG7540)
Reset hardware of the

COMMON INTERFACE

CAM RESET
CAM module
CAM status module
CAM CONTROL
verification
Enter the OSD navigation
CI MENU
of the CAM
Confirm the settings by pressing the key; save the settings by
pressing the S key after the modules programmation.
IMPORTANT: The CAM menu depends on the specific model acquired. Full interaction with some types
of CAM might not be possible using the TPE (refer to the technical specifications of the CAM manufac-
turer).
In the "CAM CONTROL" MENU, all the messages from the CAM when it is operating can be displayed; it is also
possible to interact with the CAM using TPE. A message "Not allowed" is displayed in the event that the CAM
does not need the user's intervention. To visualize the CAM MENU use the OSD mode.
6. FIRMWARE UPDATING INSTRUCTIONS
To update the firmware of the modules, refer to the download section of our internet web site www.fracarro.
com.
27