Hkoenig KBP40 Manual De Usuario página 21

Drain plug
TROUBLESHOOTING
Problem
indicator turns on
indicator lights up
indicator blinks
The ice maker stops
working.
The ice basket is full but
the " " indicator does not
illuminate.
The ice collects together.
Drain plug
Fig.2
Possible causes
1.Low water level or lack of water
2.The water screen at the bottom of
water reservoir is blocked.
3. Pump malfunction.
4.The water inlet of Ice Maker is not
connected with external water
source, or the external water
source is closed.
1.Ice basket is full and the infrared
light is blocked by the ice.
2. Infrared light-emitting diode &
light-receiving diode do not work
The ice shovel is blocked.
The ice tray is not in the right position.
The "ice full" condition can not be
detected as the infrared light module
is interfered by the sunlight.
Making ice takes too much time.
Fig.3
Solution
1. Stop making ice, refill water and then press
key to restart ice-making cycle.
2. Do cleaning.
3. Send it to the authorized department for
repair.
4. Check and make sure the external water
source is connected well or opened.
1.Remove the ice from ice basket.
2a. Wipe up the foreign objects on the infrared
light-emitting diode & light-receiving diode and
restart the ice maker.
2b. Call Customer Service if the infrared light-
emitting diode & light-receiving diode still can not
work after wiping up the foreign objects on them
and restarting the ice maker.
Please remove the ice if the ice shovel is blocked
by ice, otherwise, call customer service for
consultation.
1. Remove the ice in the ice tray and press
the " " key to restart the appliance.
2. Call Customer Service if the appliance still
can not work after restart.
Unplug the appliance and move it to a place
which is not exposed to the sunlight, then plug
the appliance and activate it again.
Stop making ice and restart the ice-making cycle
after the ice melts.