Setting Ptz Presets - Lorex LNZ32P4 Serie Manual De Instrucciones

7 Controlling the PTZ camera with LNK Series NVRs
1. Channel: Select the channel of the PTZ camera you want to control.
2. Navigation Controls: Click the directional arrows to move the PTZ camera. Click
to begin autopan (PTZ camera pans around automatically).
3. Start Cruise: Cycles between preset viewing points automatically.
4. Close PTZ Controls
5. Speed: Set the speed of the PTZ camera's movement.
6. Zoom: Click –/+ to zoom in or out.
7. Focus: Click –/+ to adjust the focus.
8. Iris: Click –/+ to set the iris. Adjusting the camera's iris settings allow you to control the
amount of light that enters the camera's lens. The higher the iris value, the greater the
amount of light that enters the camera's lens.
CAUTION
Adjust the camera's iris settings to match the environment where the camera is installed. Too much
light exposure might result in a very bright camera image.
9. Preset: Click to access preset settings. For details on setting presets, see 7.1.1 Set-
ting PTZ Presets, page 21

7.1.1 Setting PTZ Presets

Access the PTZ control menu to set preset viewing points for the PTZ. This is helpful for
saving frequently-monitored areas for quick viewing. Once you have saved a few preset
viewing points, you can start a PTZ cruise to switch between preset points automatically
by clicking .
To set PTZ presets:
#LX400075; r.41474/44665; en-US
21