Dometic PERFECTWALL PW 1000 Instrucciones De Uso página 20

Operating the awning
➤ Press the button
extended to the required position. Position the struts vertically and back under
the lead rail every 30 cm so that the awning stays secured at all times.
➤ Press the switch
retracted far enough to tauten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
Positioning the struts on the ground
!
WARNING! Beware of injury
• Only position the struts on solid ground.
• Secure the struts from slipping.
➤ Position the struts vertically underneath the lead rail.
➤ Secure the struts with pegs (fig. 9, page 6).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. 0, page 6).
Securing the struts on the vehicle
You can secure the awning on your vehicle directly if you have already mounted the
latches for the struts.
➤ Slide the cover of the latch up (fig. a, page 7).
➤ Fit the struts into the latch (fig. a, page 7).
➤ Slide the cover of the latch down (fig. a, page 7).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. b, page 7).
20
of the switch or the remote control until the awning is
of the switch or the remote control until the awning has
PW1000, PW1500, PW1750
EN