PW1000, PW1500, PW1750
7.4
Unrolling the blind (only PW1750)
➤ Open the lock in the middle of the lead rail (fig. d, page 8).
➤ Push the brackets on the right and left into the rails of the roller blind (fig. e,
page 8).
➤ Guide the tensioning belts or cords through the loops of the brackets (fig. e,
page 8).
➤ Pull the roller blind down evenly with both hands at the rails (fig. f, page 8).
The maximum extension height is 1.2 m.
➤ Secure the brackets on the right and left using the struts (fig. g, page 9).
or
➤ Secure the cords with pegs (fig. h, page 9).
7.5
Rolling up the blind (only PW1750)
➤ Loosen the fasteners of the roller blind.
➤ Pull the roller blind down (fig. i, page 9).
✓ The blind then rolls itself into the lead rail.
➤ Pull the brackets on the right and left out of the rail (fig. j, page 10).
➤ Lock the lock in the middle of the lead rail (fig. k, page 10).
A
NOTICE! Beware of damage.
If the roller blind is rolled up when wet, roll it out again at the next
opportunity and let the fabric dry out. If the wet fabric stays rolled up
for a long time, mildew will form and the fabric can fade.
EN
Operating the awning
23