Troubleshooting Guide - Belle Group POKER POWER UNIT Manual Del Operador

Problem
Engine will not start.
Engine still will not start.
MAINTENANCE
The Belle Group Poker Power Units are designed to give many years of trouble free operation. It is, however, important that the
simple regular maintenance listed in this section is carried out. It is recommended that an approved Belle Group dealer carries out all
major maintenance and repairs. Always use genuine Belle Group replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine. For petrol machines, disconnect the HT lead from the
sparkplug. For diesel engined machines, ensure that the fuel cock is closed. Always set the Power Unit on level ground to ensure any
fl uid levels will be correctly read. Only use recommended oils (see chart below).
Running In Period
When the Poker Power Unit is fi rst used from new, the engine oil must be changed after the initial running in period (see engine
manual for full detail).
Routine Maintenance
Engine Oil Check Level
Change
Air Filter Check Condition
Clean / Replace
Spark Plug Check / Clean
Oil/Fuel Type & Quantity - Spark Plug Type
Petrol Honda
Engine GX120
Petrol Honda
Engine GX160
Petrol Robin
Engine EX17
Diesel Hatz
Engine 1B20
Diesel Lombardini
Engine 15LD225

Troubleshooting Guide

Cause
No fuel getting to engine.
Engine switched off.
Spark plug fouled.
Engine cold.
Engine fl ooded.
Major Fault.
After fi rst
Oil Type Quantity
SAE 0.6ltrs
10W-30
SAE 0.6ltrs
10W-30
SAE 0.6ltrs
10W-30
Refer to 0.9ltrs
Manual
SAE 0.8ltrs
15W-40
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean, check and reset plug gap.
Close choke.
Honda, Open choke, fully open throttle pull recoil starter until
engine fi res.
Yanmar, move speed control to stop, pull recoil starter 5 times
then repeat start procedure.
Contact Agent or Belle Group.
Servicing
First month
4 hours / 20h
Fuel Type Capacity
Unleaded
Unleaded
Unleaded
Diesel
(BS2869)
Diesel
(BS2869)
9
3 months
/ 50h
Spark Plug
Type
2.5ltrs BM6ES or
BMR6EA
3.6ltrs BM6ES or
BPR6ES
3.8ltrs NGK B-6HS
BMR6EA
3.0ltrs n/a
2.5ltrs n/a
GB
GB
6 months
/ 100h
Electrode
Gap
0.7 - 0.8mm
0.6 - 0.7mm
0.6 - 0.7mm
n/a
n/a