Alarm On/Off Mark On The Display; Attaching The Arm Cuff; How To Take Proper Measurements; Measurement - A&D UA-853 Manual De Instrucciones

Alarm ON/OFF Mark On The Display

When the alarm is on, a "
simply press the AM button once.
The alarm will sound for 1 minute. To stop the alarm sound, press any button once.

Attaching The Arm Cuff

1. Wrap the cuff around the upper arm,
about 2-3 cm above the elbow, as shown.
Place the cuff directly against the skin, as
clothing may cause a faint pulse, and
result in a measurement error.
2. Constriction of the upper arm, caused by
rolling up a shirtsleeve, may prevent
accurate readings.
3. Confirm that the index
the proper fit range.

How To Take Proper Measurements

For the most accurate blood pressure

measurement:

Sit comfortably at a table. Rest your arm on
the table.
Relax for about five to ten minutes before
measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath. Rest
for twenty or thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.
Measurement
During measurement, it is normal for the cuff to feel very tight. (Do not be
alarmed).

After Measurement

After measurement, press the START button to turn off the power. Remove
the cuff and record your data.
Note: The device has an automatic power shut-off function, which turns the
power off automatically one minute after measurement. The clock
display remains on the LCD.
Allow at least ten minutes between measurements on the same person.
Using The Monitor
" appears on the LCD. To turn the alarm off,
points within
English 8
Rolled up shirtsleeve
Cuff
2 -3 cm
Constriction of the Upper Arm
Index and Proper fit range
Air Hose