Operation Mode; Measurement With The Desired Systolic Pressure - A&D UA-853 Manual De Instrucciones

1. Normal Measurement With Storing Data
Press the START button. Blood pressure is measured and data is stored
within the device. The device can store the last ninety sets of data in
memory.
2. Recalling The Data
Press the MEMORY button to recall the data.
The average data of all the previous
measurements and the number of data are
displayed, as indicated in the figure at the
right.
Further key operation will recall the average
data during the AM, the average data during
the PM and data of each measurement.
For details on recalling data, refer to
"Recalling Memory Data" on pages 11 and
12.
The device can store the last ninety sets of
data in memory.
3. Clearing The Data
Press and hold the MEMORY button until the "
(memory) mark blinks to clear the stored data.

4. Measurement With The Desired Systolic Pressure

Refer to page 10 for the measurement with the desired systolic pressure.

Operation Mode

(Refer to pages 11 and 12)
(Refer to page 11)
English 5
(Refer to page 9)
Press the MEMORY button
M
Averaged systolic
Averaged diastolic
Number of data
Average of
all the data
"