EAS ELECTRIC EHD20DA Manual De Usuario Y Manual De Instalacion página 38

reducing the risk of mould and bacterial growth. To
disable the function, press the Pure pad for 3 seconds
or select an operating mode with the Mode pad.
Self-clean(On some models)
Press the Turbo pad for 3 seconds to enable this
function. This function initiates as soon as the unit is
switched off, and runs 15 minutes under high fan
speed.
Air purifier function(On some models)
This function significantly reduces the dust, bacteral
and allergen content of the room, using the HEPA(High
Efficiency Particulate Air) filter supplied with the unit.
Press the Pure pad to activate
the Air purifier function,
all other modes and special
functions are inhibited while
it is running. Make sure you
have fitted the HEPAfilter as
indicated in fig.A.
Setting the Timer(With 1 indicator light)
·
Press to initiate the Auto start or Auto stop feature, in
conjuction with the UP and DOWN buttons.
· When the unit is on, press the Timer button to
actieve the Auto Stop feature. When the unit is
off, press this button to actieve the Auto start
feature.
· Press or hold the UP or DOWN button to
change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments, up
to 24 hours. The control will count down the
time remaining until start.
· The selected time will register in 5 seconds and
the system will automatically revert back to
display the previous humidity setting.
· Turning the unit On or Off at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
· When LED display window is plays the code of
P2, the Auto Start/Stop function will also be
cancelled.
Setting the Timer(With 2 indicator lights)
·
When the unit is on, first press the Timer button, the
Timer Off indicator light illuminates. It indicates the
 
Page 16
HEPA filter
Air intake grill
V.1
Auto Stop program is initiated. Press it again the
Timer On indicator light illuminates. It indicates the
Auto Start is initiated.
· When the unit is off, first press the Timer
button, the Timer On indicator light
illuminates. It indicates the Auto Start program
is initiated. Press it again the Timer Off indicator
light illuminates. It indicates the Auto Stop is
initiated.
· Press or hold the UP or DOWN button to
change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments, up
to 24 hours. The control will count down the
time remaining until start.
· The selected time will register in 5 seconds and
the system will automatically revert back to
display the previous humidity setting.
· When the Auto start & Auto stop times are set,
within the same program sequence, Timer On
Off indicator lights illuminate identifying both
On and Off times are now programmed.
· Turning the unit On or Off at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
· When LED display window is plays the code of
P2, the Auto Start/Stop function will also be
cancelled.
AUTO mode(On some models)
The unit can be set desired humidity level, fan speed
and louver swing feature.
SHOES mode(On some models)
The unit can make the MAX dehumidification function
whenit is under the SHOES mode. The fan speed is
fixed at high fan speed and the louver will stop swing.
The unit will quit SHOES mode after a maximum 2
hours' operation.
Take down the SHOES
dryer cover
Install the SHOES dryer
pipe to the unit
Put the SHOES dryer
pipe to the shoes
After using, take down
the SHOES dryer pipe