Removing The Collected Water - EAS ELECTRIC EHD20DA Manual De Usuario Y Manual De Instalacion

CLOTHES/Dryer mode(On some models)
The unit can make the MAX dehumidification function
when it is under CLOTHES/Dryer mode. The fan speed is
fixed at high fan speed. For some models, the swing
feature can be set. For some models, the humidity level is
automatically controlled according to the actual room
humidity. The unit will quit dryer mode after a maximum
10 hours' operation.
Note:
1. The dryer mode must be operated in a close room, do

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
· When the unit is off,if the bucket is full, the unit will
beep 8 times(on some models) and the Full Water
indicator light will flash.
· (For some models)When the unit is on,if the bucket is
full, the compressor turns off and the fan turns of f after
30 seconds for drying the water of the condenser , then
the unit will beep 8 times and the Full Water indicator
light will flash.
· Slowly pull out the bucket. Grip the left and right
handles securely , and carefully pull out straight so
water does not spill. Do not put the bucket on the
floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to
spill.
· Throw away the water from the water outlet and
replace the bucket. The bucket must be in place and
securely seated for the dehumidifier to operate.
· The machine will re-start when the bucket is restored
in its correct position.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even strength,
and pull it out from the unit.
3. Pour the water out.
not open the
door and window.
2. To make the best effective
dehumidification, please first
dehydrate the wet clothes.
3. Make sure to direct airflow
at the wet clothes.
4. For thick and heavy wet
clothes may not get the best
effective dehumidification.
Note:
· When you remove the bucket, do not touch any
parts inside of the unit. Doing so may damage the
product.
· Be sure to push the bucket gently all the way into
the unit. Banging the bucket against anything or
failing to push it in securely may cause the unit
not to operate.
· When you remove the bucket, if there is some
water in the unit you must dry it.
2. Continuous draining
· Water can be automatically emptied into a floor
drain by attaching the unit with a water hose(not
included).
· Remove the rubber plug or cut
the cover down from the back
drain hose outlet. Attach a
drain hose and lead it to the
floor drain or a suitable
drainage facility.
· Make sure the hose is secure
so there are no leaks.
· Direct the hose toward the drain,making sure that
there are no kinks that will stop the warter flowing.
· Place the end of the hose into the drain and make
sure the end of the hose is level or down to let the
water flow smoothly. Do never let it up.
· Make sure the water hose is lower than the drain
hose.
· Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
Note: When the continuous drain feature is not
being used,remove the drain hose from the outlet
and reinstall the rubber plug.
V.1
Wet clothes
30~50cm
30~50cm
Airflow
Allow 30~50cm
of distance on the
top and right side
of the unit to the
wet clothes.
Remove the
rubber plug
Attach the hose to the drain
hose outlet.
 
Page 17