Perel EDB5 Manual Del Usuario página 4

4 selectable sounds
•
5. Overview
Refer to the illustrations on page 2 of this manual.
1 status LED
2 speaker
3 belt clip/mounting hole
A open screw (behind name tag)
B status LED
6. Operation
Make sure batteries are present inside the doorbell and doorbell
•
pushbutton (see §8).
Mount the doorbell pushbutton in a location where it is protected from
•
harsh weather conditions (IP44).
Press and hold the CODE button [4] for ±3 seconds until status LED [2]
•
flashes. Within 15 seconds, press the doorbell push button [B] to set
the transmitting code.
Mount the doorbell itself in a dry indoor location. It can also be carried
•
around when desired.
Note: normal range without obstructions is ±40m. Walls, metal frames
and some appliances (e.g. working microwave ovens, radios... ) will
reduce this range.
Press the melody select button [5] to select the desired melody (4
•
options).
7. Troubleshooting
When sound becomes weak, replace the batteries of the doorbell
•
(see §8).
When pushing a push button does not produce a chime:
•
verify whether the push button is located within the specified
o
range (max. 40m). If not, bring it closer to the doorbell.
verify whether doorbell and doorbell push button is not
o
surrounded by metal or near a strong magnetic field. In these
cases, move the push button or doorbell to a suitable location.
replace the push button battery (see §8)
o
8. Batteries
doorbell
Open the battery compartment [6].
•
Insert 2 new 1.5V batteries type AA (LR6C) with polarity as
•
indicated inside the battery casing.
Close the battery compartment.
•
21/12/2011
EDB5
4 CODE button
5 melody select button (SEL)
6 Battery compartment
C push button
D mounting holes
4 ©Velleman nv