fischertechnik ROBO TX Controller Manual De Instrucciones página 147

R O B O T X C
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada
Operation is subject to the following two conditions:
(1) this device my not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly approved by fischer-
technik may void the FCC authorization to operate this equipment.
The radiated output power of RF-Data-Link is far below the FCC radio frequency exposure limits.
Nevertheless, the RF-Data-Link shall be used in such a manner that the potential for human
contact during normal operation is minimized.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
148
O n T R O l l e R