Install Software - fischertechnik ROBO TX Controller Manual De Instrucciones

R O B O T X C
13 Universal inputs I1–I8
These are the all-rounders among the signal inputs. They can be set with the software,
ROBO Pro, for:
• Digital sensors (push button switches, reed contacts, phototransistors) – digital 5 kΩ
• Infrared trail sensors – digital 10 V
• Analog sensors 0–5 kΩ (NTC resistors, photoresistors and potentiometers)
• Analog sensors 0–10 V (color sensors) display of value in millivolts (mV)
• Ultrasonic distance sensors (only the version TX with three-wire connection)
14 EXT 1, connection for expansions
With this connection, additional ROBO TX Controllers can be connected the same as for
EXT 2 and so the number of the inputs and outputs can be expanded.

Install software

Software prerequisite for the ROBO TX Controller:
ROBO Pro version 2.0 or higher
In the handbook for the ROBO Pro software, the following, among other things, are described in
detail:
• The installation of the ROBO Pro software on the PC.
• The installation of the USB driver for the ROBO TX Controller for the Windows operating
systems.
24
I
O n T R O l l e R n s T R u C T I O n
M
a n u a l