HEINE EN200 Instrucciones De Uso página 7

Setting up
Primary plug EN200
EU USA / Japan
Primary plug E4 USB
EU USA / Japan
The device must only be operated at the mains voltage specified on the type plate.
EN200
- Attach the primary plug to the plug-in transformer until it engages.
- Connect the device to the mains with the plug-in transformer. The green indicator light on the EN200
illuminates.
EN200-1
- Connect the USB cable on the back of the EN200-1 to the plug-in power pack, push the primary
adapter onto the plug-in power pack until it engages, and then connect this to the mains supply.
The green pilot light on the EN200-1 lights up.
Connecting instruments
The cable handles are fitted with HEINE automatic connectors for
use with all similarly equipped HEINE instruments.
- Hold the handle in one hand and insert the instrument connector
into the guides in the handle head.
- Push the instrument into the handle until it locks in place with an
audible "click".
- Instruments can be locked to prevent unauthorized removal by
using the enclosed allen wrench according to fig. 1.
- To unlock, the screw may only be unscrewed so far until the
connector can be turned.
- The instrument is ready for operation when taken off the unit.
- To adjust the brightness of the instrument activate the adjustment
ring on the handle.
- Both handles can be simultaneously used independent of each
other.
- To remove the instrument turn the upper conical ring to the right
and pull the instrument off.
The device enters power saving mode, if the handles are taken off the unit and are not used for
more than 15 minutes. The handles are activated by adjusting the brightness or by placing the
handle back and taking it off the unit again.
The setting up and operation of the HEINE instrument heads are described in a separate instruction
of use.
UK Australia
UK Australia
MED 113066 2019-02-06
Fig. 1
7/44