Troubleshooting - Black and Decker HV9010 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: Never use the appliance without the filters. Optimum dust collection will
only be achieved with clean filters and an empty dust bowl. If dust begins to fall
back out of the appliance after switching it off, this indicates that the dust bowl is full and
must be emptied.
Cleaning the turbo brush
First remove the turbo brush from the unit. Press the button on the front of the brush and lift
the top off. There may be some hair, dust, lint, etc. on the turbine wheel and or brush.
Remove as much of this as possible. Once cleaned replace the top and snap back in place
(see figures E1, E2 and E3).
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement filters are available from your Black & Decker dealer (cat. no. HVF91).
• Remove the old filters as described above.
• Fit the new filters as described above.
Storage
• Wrap the power supply cord around the appliance.
• Store the appliance and the attachments in a dry location out of the reach of children.
Cleaning/Maintenance
WARNING:
Before cleaning and maintenance, switch the appliance off and
unplug it.
From time to time wipe the appliance with a damp cloth. Do not use any abrasive or sol-
vent-based cleaner. Never let any liquid get inside the tool; never immerse any part of the
tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.

TROUBLESHOOTING

Problem
Possible Cause
• Unit will not start.
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
WARNING:
The use of any accessory not recommended for use with this tool
could be hazardous.
Service Information
Black & Decker offers a full network of company-owned and authorized service locations.
All Black & Decker Service Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you need technical advice, repair,
or genuine factory replacement parts, contact the Black & Decker location nearest you.
SPECIFICATIONS
HV9010-HV9010P AR
B2
Voltage
220V
220V
Frequency
50Hz
60Hz
Power
800W
800W
Possible Solution
• Plug tool into a working
outlet.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at Black &
Decker Service Center or
Authorized Servicer.
B3
B2C
BR
120V
220V
127V
60Hz
50Hz
60Hz
800W
800W
800W
Solamente para propósito de Argentina:
Importado por: Black & Decker Argentina S.A.
Pacheco Trade Center
Colectora Este de Ruta Panamericana
Km. 32.0 El Talar de Pacheco
Partido de Tigre
Buenos Aires (B1618FBQ)
República de Argentina
No. de Importador: 1146/66
Tel. (011) 4726-4400
Imported by/Importado por:
Black & Decker do Brasil Ltda.
Rod. BR 050, s/n° - Km 167
Dist. Industrial II
Uberaba ˆ MG ˆ Cep: 38064-750
CNPJ: 53.296.273/0001-91
Insc. Est.: 701.948.711.00-98
S.A.C.: 0800-703-4644
Solamente para propósitos de CCA
Importado por: Black & Decker LLC
Calle Miguel Brostella Final
Edificio Milano I, Mezanine 5,6 y 7
El Dorado, Panama
Tel. 507-360.5700
Solamente para propósitos de Colombia
Importado por: Black & Decker de Colombia, S.A.
Carrera 85D # 51-65, Bodega 23
Complejo Logístico San Cayetano
Bogota - Colombia
Tel. 744-7100
Solamente para propósito de Chile:
Importado por: Black & Decker de Chile, S.A.
Av. Pdte. Eduardo Frei M. 6001-67 Conchalí
Santiago de Chile
Tel. (56-2) 687 1700
Solamente para propósito de México:
Importado por: Black & Decker S.A. de C.V.
Bosques de Cidros, Acceso Radiatas No.42
3a. Sección de Bosques de las Lomas
Delegación Cuajimalpa,
05120, México, D.F.
Tel. (52) 555-326-7100
R.F.C.: BDE810626-1W7
Black & Decker del Perú S.A.
Av. Enrique Meiggs 227.
Pque. Industrial - Callao
Teléfono: (511) 452-5577
RUC 20266596805
Impreso en China
Impresso na China
Printed in China
188217-00
08/27/07

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hv9010p

Tabla de contenido