Pioneer MVH-S405BT Manual De Instrucciones página 19

Menu Item
SUBWOOFER*2
[NOR], [REV]
SPEAKER LEVEL
Types of speaker: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Output level: [–24] to [10]
CROSSOVER
POSITION
[OFF], [FRONT LEFT] (front
seat left), [FRONT RIGHT]
(front seat right), [FRONT]
(front seats), [ALL]
TIME ALGNMNT
[INITIAL], [OFF], [CUSTOM]
Select a type of speaker and
adjust the speaker distance
for further customizing in
[CUSTOM].
Types of speaker: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Speaker distance (cm): [350]
to [0.0]
Description
Select the subwoofer phase.
Select a speaker unit (filter) and adjust the
output level.
• Each value you have adjusted changes
when you change the [POSITION] setting
(page 19).
Select a speaker unit (filter) to adjust the
HPF or LPF cut-off frequency and the slope
for each speaker unit.
For details on the [CROSSOVER] setting, see
page 16.
Select a listening position to adjust the
speakers' output levels automatically and
add a delay time that corresponds to the
number and locations of occupied seats.
Select or customize the time alignment
settings to reflect the distance between the
listener's position and each speaker.
• Select [INITIAL] to initialize the setting
value.
• Select [OFF] to reset all setting values to
0.
• The [CUSTOM] setting is available when
[FRONT LEFT] or [FRONT RIGHT] is
selected in [POSITION] (page 19).
• The [CUSTOM] setting is not available
when [OFF] is selected in [SUBWOOFER]
(page 18).
Menu Item
SAVE SETTINGS
[YES], [NO]
LOAD SETTINGS
D.BASS
[OFF], [LOW], [HI]
LOUDNESS
[OFF], [LOW], [MID], [HI]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
Description
Save to later recall the following sound
settings at their current values:
[CROSSOVER], [SPEAKER LEVEL], [EQ
SETTING], [POSITION], [TIME ALGNMNT],
[D.BASS], [SUBWOOFER].
Load the sound settings, when you have
already performed [SAVE SETTINGS].
Boost the bass level dynamically to offer an
effect as if a subwoofer was added to the
system.
Compensate for clear sound at low volume.
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
• When making a USB connection, set USB,
iPod, PANDORA, ANDROID, SPOTIFY, and
APP.
• When making a Bluetooth connection,
set BT AUDIO, iPod, PANDORA, ANDROID,
SPOTIFY, and APP.
19
En