Cutting Operation - Makita XSJ04 Manual De Instrucciones

Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
Lubrication
NOTICE:
Use the standard machine oil for steel
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A The cutting area of the workpiece.
B The part of the center blade which contacts to the
workpiece.
C The both sides of the center blade which contacts
to the side blade L and side blade R.
B
A
1
2
3
C
C
Adjusting cutting head angle
CAUTION:
Make sure the cutting head is
secured in the position after adjusting the cutting
head angle. Otherwise the cutting head may rotate
during operation and cause serious injury.
Rotate the cutting head while pushing the rotation
button.
Release the rotation button when the cutting head is in
the desired angle.
► 1. Rotation button

Cutting operation

CAUTION:
Wear gloves. Edges and chips of the
workpiece are sharp and may cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
2
► 1. Side blade 2. Workpiece
8 ENGLISH
1
1