Power Supply - Aiwa CS-P700 Instrucciones De Manejo

WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
NOTE
AIWA CO. LTD. - JAPAN - DECLARES UNDER ITS
OWN RESPONSIBILITY THAT THE PRODUCT
DESCRIBED IN THIS MANUAL IS IN COMPLIANCE
WITH THE DIRECTIVES OF D.M 28.8.95 No. 548,
ACCORDING TO THE STIPULATIONS OF
PARAGRAPH 3 OF ATTACHMENT A OF D.M.
25.6.85 AND PARAGRAPH 3 OF ATTACHMENT 1
OF D.M. 27.8.87 (REGULATIONS REGARDING
FREQUENCIES).
The above information is only for Italy.
Precautions
Power sources
Use on batteries or AC house current, as specified
in the Operating Instructions and marked on the
unit.
On placement
• Do not use the unit in places which are extremely
hot, cold, dusty or humid. In particular, do not
keep the unit:
• in a high humidity area such as a bathroom
• near a heater
• in an area exposed to direct sunlight (e.g.,
inside a parked car, please be careful because
it may become extremely hot)
• Place the unit on a flat, even surface.
For safety
Take care that objects or liquids do not get inside
the unit.
When not in use
Disconnect the AC adaptor and remove all the
batteries if the unit will not be used for a long period
of time. When the cord is plugged in, a small
amount of current continues to flow to the unit even
when the unit is not being used.
If an erroneous display or malfunction occurs
Press the reset hole (RESET) with a thin stick or a
similar tool.
2
ENGLISH

Power Supply

Using on batteries
Open the lid of the battery compartment on the rear
and insert four R6P (size AA) batteries, not
supplied, with the 0 and 9 marks correctly aligned.
Then close the lid.
• Before using on batteries, disconnect the AC
adaptor from the DC 6V jack. Battery power is cut
off automatically when the AC adaptor is
connected.
The batteries need to be replaced when:
The OPE/BATT indicator becomes dim, the tape
speed slows down, volume decreases, or sound is
distorted during operation.
Notes on batteries
• Do not mix different types of batteries or old
batteries with new ones.
• Never recharge the batteries, apply heat to them
or take them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
R6P (AA) × 4