fadini Bart 350 Manual De Instrucciones página 14

ATTENTION: USING NON-FADINI ACCESSORIES MAY DAMAGE
THE BOARD. USE ONLY CLEAN CONTACTS WITH NO-NC INPUTS.
BRIDGE ALL UNUSED NC CONTACTS
22V
OFF ON
BART MASTER
TORQUE Trimmer
BART SLAVE
TORQUE Trimmer
Internal
receiver
photocell
External
receiver
photocell
LED lamp
NOTE WELL: All of the possible connections to the programmer terminal boards are also illustrated in the respective instructions sheets for each individual
accessory.
pg. 24
Transformer
230V
power
BART 350
SLAVE 3x1.5
Elpro 35M
on BART 350
Master
microprocessor
24Vdc output for max load 500mA:
2 pairs of photocells
1 Radio receiver
1 Chis 37 /Chis E37 LED or DGT61 board
NOTE WELL:
The LEDs shown here are in the normal state for the
proper functioning of the
The green LEDS should be always on.
5A
External power supply
230V 50Hz ± 10%.
For distances longer
than 50 m increase
wire sq. section.
Terminals
with fuse
24V motor
Encoder
Motor
LINK
Installation for a
single gate Brid-
ge A-C and B-D
Instructions
ELPRO
board.
IMPORTANT: the programmer recognises
the limit switches upon connector
insertion. Every time the connector is
inserted or removed,
YOU MUST:
1) REMOVE AND THEN RESTORE
Unlocking
ELECTRICAL POWER AFTER A FEW
handle
SECONDS
switch
2) PROGRAM BART 350
Opening Limit
switch LED
Limit switch connector
Closing limit switch LED
Plug-on radio
connector
Trimmer
PAUSE
Programming button
Common
Pedestrian
Courtesy lamp
relay output
max 24V 50mA
Communication with Elpro 35S
of Bart 350 Slave on the second
gate (opening delayed), pg. 26
LED on
LED flashing
LED off