Names And Operations; Remote Control - Panasonic CZ-RWSU2 Manual De Instrucciones

2. Names and Operations

REMOTE CONTROL

1. Operation Display
Displays the operation status. (The fi gure
shows all the statuses.)
• The auto-fl ap display may be different,
depending on the installed unit. (See Page
EN-11)
2. Start/Stop button
Pressing this button once starts and pressing
again stops the operation.
3. Fan speed button
4. Swing/Wind Direction button
5. Timer setting button
Use for operating with a timer.
6. Reset button
Use this button after changing the batteries.
7. Cover
Press at the top center and then slide down.
8. Transmitter
9. Remote control sensor
Detects the temperature at the remote
controller when detection has been switched
to the remote control by the sensor button.
10. Temperature setting buttons
raises the temperature setting 1 °C at
a time.
lowers the temperature setting 1 °C at
a time.
One remote control can control a group of up to eight indoor units.
(See Page EN-12)
11. Filter button
12. Mode Select button
13. Ventilation button
14. Address button
15. Sensor button
16. Clock button
From this page on the names of remote control
buttons will be abbreviated as the illustration of
the "button".
E.g.: Start/Stop button
EN-3
CZ-RWSC2
Press to turn off the fi lter lamp on the
receiver.
Press to switch the operation mode.
Use this when connected to an aftermarket
fan. Pressing this button starts and stops the
fan. When the air conditioner is started or
stopped, the fan starts or stops at the same
time. ( appears on the display of the
remote control when the fan is operating.)
Use this when switching to detect the
temperature at the remote control. At
shipping the default setting is set to detect
the temperature at the unit. At this time
shown on the display.
Use this when setting the clock.
EN
is