Ferax ZW01-20B Manual De Instrucciones página 14

3. ATTENTION POINTS FOR HOSE USE
The reel has a high quality kink resistant hose supplied.
1. After use, please turn off the water. In some areas of high tem-
peratures and high water pressure, the sunlight will heat the
water and damage the hose, which will cause the hose to be
difficult to rewind. It is the best way to turn off the water before
retracting the hose. Do not leave the reel in the outside during
very low temperature. Under this condition, the hose may be
less flexible and difficult to retract.
2. Do not touch any chemical or substance, such as acetone, white
spirits, lactic acid etc. Please note the hose of the reel can't be
used for drinkable water except additional indication.
4. HOW TO LATCH AND RETRACT HOSE
CORRECTLY
66
This reel is fitted with ratchet wheel and pallet design, very easy to
extend and retract the hose. While pulling out the hose, you can
hear repeated "KADA" voice. When you pull out the hose length
needed and hear "KADA" voice, then release the hose so you can
latch it (Fig.7, picture when the ratchet is in use, V is the pulling
direction of hose), When you retract the hose, pull out about
300MM and no "KADA" voice; you can retract the hose now. To
retract, it is suggested that a minimum of 25% of the hose has been
extended. During retraction, always hold the nozzle and follow the
retraction until it is finished. When the hose twists, it is necessary
to extend the hose to full length then allow retracting, so to smooth
the hose, let it evenly retract back to the reel.
Fig. 5
5. MAINTENANCE
1. Do not immerse the reel in water to clean. If hose is very dirty,
please clean it before retraction.
2. The way is to mount the reel in a sheltered position to prolong
its life. The metal parts will deteriorate and rust in exposed
positions. Also the polypropylene parts will be affected when
exposed outside, particularly under sunlight, which will affect
the life of the reel housing and retracting wheel. In the area
under freezing temperatures, the hose also will be damaged if
the hose is full of water.
3. When not in use, it is advisable to store your reel.
4. If the hose cannot be retracted after using for a certain time,
Fig. 6
maybe it is the spring that is fatigued. So the stress of spring
should be adjusted by 1-2 turns: firstly, discharge the left cover
from reel, clamp the head of spring, make it away from reel;
then swivel anti-clockwise the unit for 1-2 turns, restore the
spring head to the reel; lastly, replace the left cover.
6.TECHNICAL PARAMETER
MODEL
HOSE LENGTH
HOSE MATERIAL
PRESSURE
INNER DIAMETER OF HOSE
SIZE OF INLET FITTING
7.ACCESSORIES
One mounting bracket, one aluminum tube, four screws (M8x63),
one spray nozzle.
Fig. 7
12
ZW01-20B
20m (66.6Ft)
PVC
MAX 1.0MPa (150PSI)
1/2"(12mm)
3/4 NPT