Optional Accessories - Dolmar AH1851 Manual De Instrucciones

Set the angle of a file to 45°, and grind the upper
5.
blade from 3 directions with the file.
► Fig.36: (1) File (2) 45°
CAUTION:
Before grinding the shear blades,
make sure that the tool is switched off and the
battery cartridge is removed from the tool.
Place the tool upside down, and then remove the
6.
burrs from the shear blades with the file.
► Fig.37: 1. File
Set the angle of the file to 45°, and grind the lower
7.
blade from 3 directions with the file.
8. Return the tool to normal position, and then
remove the burrs from the shear blades with the file.
Attach the branch catcher by tightening the screw.
9.
Grease lubrication
Interval of lubrication: Every 100 operating hours
Remove 3 screws, and then remove the bottom
1.
cover.
► Fig.38: 1. Screw 2. Bottom cover
2. Remove the cap from the grease vessel, and then
attach the grease vessel to the hole on the cover by
turning the grease vessel.
► Fig.39: 1. Cover 2. Grease vessel
Apply the grease to the tool (Approximately 5 g as
3.
a guide).
4. Remove the grease vessel.
Attach the bottom cover, and then tighten 3
5.
screws.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita/
Dolmar tool specified in this manual. The use of
any other accessories or attachments might present
a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita/Dolmar
Service Center.
• Shear blade assembly
• Shear blade cover
• Chip receiver
• Grease vessel
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
15 ENGLISH