dirna Bergstrom bycool green line SLIM FIT Instrucciones De Montaje página 12

SLIM FIT
EN
Assembly
Recommendations
• Before starting assembly, please read instructions
and follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely
connected, checking their correct fitting.
! Warning
If the unit slants during assembly, wait for at
least 60 minutes with the unit in horizontal
position before starting it up.
! Warning
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Slimfit on roof, take into account that, normally,
cabins equipped with a hatch have a strong enough
structure to hold equipment weight. However, if it is not
the case and it is necessary to carry out a cut in the roof
or, although it has a hatch, the material is not resistant
enough (if roof is made of fibre, plastic, etc...), it is the
installer who will have to decide, under his responsibility,
if it is necessary to reinforce the roof to avoid possible
deformations, breaks, water entries, etc., habilitating the
means required to stop it from occurring.
Torx wrenches set
Allen wrenches set
Open-jawed spanner 13, 25
Scissors
Flexo-meter
Screwdriver
Documentation included
Mounting instructions
User's guide
Troubleshooting
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
dirna Bergstrom, s. l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Equipment pre-charged with refrigerating gas.
(Do not handle refrigerating gas circuit).
!
Please see product warranty procedure included in
Troubleshooting diagnosis.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting Diagnosis.
!
The unit does not comply with ADR regulations.
12
Tools
1001249409
220AA35378
220AA35379
Symbology
!
Warnings
®