Before Use; Fitting The Battery; Charging The Battery; Removing The Battery - Hilti WSC 70-A36 Manual De Instrucciones

Ocultar thumbs Ver también para WSC 70-A36:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52

6 Before use

6.1 Battery use and care
en
NOTE
Battery performance drops at low temperatures. Never
use the battery until the cells become fully discharged.
Change to the second battery as soon as a drop in per-
formance is noticed. Recharge the battery immediately
so that it is ready for reuse.
Store the battery in a cool, dry place. Never store the
battery where it is exposed to direct sunlight or sources
of heat, e.g. on heaters / radiators or behind a motor
vehicle windscreen. Batteries that have reached the end
of their life must be disposed of safely and correctly to
avoid environmental pollution.
Insert the battery in the corresponding charger.

6.2 Charging the battery

CAUTION
Use only the Hilti chargers listed under "Accessories".
DANGER
Ensure that the outer surfaces of the battery are clean
and dry before inserting it in the corresponding char-
ger. Read the operating instructions for the charger
for further information about the charging procedure.
6.2.1 Charging a new battery for the first time
A new battery must be charged correctly for the first time
before use. This will ensure that the cells form correctly.
Incorrect initial charging may have a permanent, negative
effect on battery capacity. Please refer to the applicable
battery charger's operating instructions for information
about initial charging.
24
6.2.2 Recharging a NiCd battery
NiCd batteries should be charged fully each time they are
charged.
6.2.3 Recharging Li-ion batteries
Li-ion batteries are ready for use at any time, even when
only partly charged. Charging progress is indicated by
the LED display (see charger operating instructions).

6.3 Fitting the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
CAUTION
Check that the power tool is switched off and the
switch interlock activated before fitting the battery.
Use only the Hilti batteries approved for use with this
power tool.
1.
Push the battery into the power tool from the rear as
far as it will go and until it is heard to engage with a
double click.
2.
CAUTION A falling battery may present a risk of
injury to yourself or others.
Check that the battery is seated securely in the
power tool.

6.4 Removing the battery

1.
Press one or both release buttons.
2.
Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (working
position) and move it into the first click-stop position
(transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts of
the battery pack are not short-circuited. Remove loose
metal parts such as screws, nails, clamps, loose screw
bits, wires or metal swarf from the case, toolbox or
transport container, or prevent these parts from coming
into contact with the battery packs.
Observe national and international transport regulations
when shipping battery packs (transportation by road, rail,
sea or air).

Publicidad

Tabla de contenido
loading

Tabla de contenido