W Orking Instructions; S Ervice / M Aintenance; P Reventive Maintenance - SUHNER ABRASIVE LSB 70-TOP Documentación Técnica

Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 w
orKing instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
4. s
ervIce
4.1 P
reVentiVe mAintenAnce
Without a tool clamped in check no-load
speed periodically and after each mainte-
nance. Lubricate the valve!
4.1.1 r
ePlAcement of the exhAust Air hose
Detach the exhaust air hose, and replace it.
4.1.2 r
ePlAcement of the suPPly hose
Remove the exhaust air hose (see 4.1.1).
Detach the hose clip, and pull the supply hose off the
connection nipple.
/ m
aIntenance
17