Use And Operation - Urrea 2461N Manual De Usuario Y Garantía

E N G L I S H
illuminated and free of obstructions (2). Never stand the jack on asurface which may
sink.
• Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine
and apply the brake. Ensure the vehicle or element to be lifted against any type of
sliding. Use chocks if appropriate (3). Do not enter the vehicle or start the engine whilst
it is supported on the jack or appropriate stands (4). The jack is a lifting device only and
should never be used to move the vehicle.
• Position the jack under the manufacturer's recommended lifting point for the vehicle
and ensure that it is not corroded, dirty or greasy. This point should remain centred over
the jack saddle. All off-centred loads can slip and accidents may result.
• During raising and lowering of the load, all precautions should be taken to avoid
movement of the vehicle load. Traffic may cause the raised vehicle to rock during
roadside use of the jack.The jack should be positioned so as to avoid the need for the
user to introduce any part of his/her body underneath the vehicle. Never work under
a raised vehicle without previously supporting it with mechanical stands (4) or other
appropriate methods. Never position any part of your body near the movable elements
of the jack.
• It is necessary for the operator to be able to observe the lifting device and the load
during all movements. In the presence of dangerous conditions, such as movement of
the vehicle, etc, the lifting process must be interrupted.
• Ensure that there are no persons or obstructions underneath the vehicle prior to
lowering.

USE AND OPERATION

Prior to operating the jack, remove any accumulated air from the system as follows:
-Insert the handle into the socket and fix it with the screw provided .
-Pull the handle and turn it clockwise and, whilst held in this position , pump the jack
several times to ensure internal lubrication and bleed the accumulated air from the system.
Release the handle and it will automatically return back to the initial position ("Dead man
principle"). The jack is now ready to be used.
Important: Prior to lifting the load, ensure that all of the aforementioned safety instructions
are followed. The wheel of the jacks should always rotate freely.
6