Teac AG-H350 Manual Del Usuario página 70

If you have problems with your system, look through this chart and see if you can solve the problem yourself before calling your
dealer or TEAC service center.
No power
e Check the connection to the AC power supply.
No sound from speakers.
e Check the connection to the speakers.
e Adjust the volume.
e If muting is on, press the MUTING button.
e Set the BALANCE control to the center.
The sound is noisy.
e The unit is too close to a TV set or similar appliances. Relocate the unit , or turn them off.
Sound cuts off during listening to the music or no sound even though power is ON.
"PROTECT" is displayed
e Speaker impedance is less than prescribed for this unit. Use a speaker with an impedence of 8 (or 4 ) ohms or more. (Selected
with the switch on rear panel.)
e Turn the power off and turn it on again. Then reduce the volume.
Low bass response.
e Speaker polarity (+/_) is reversed. Check all speakers for correct polarity.
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e If a TV is near the unit, turn it off.
e Install the antenna again after locating the best reception position.
e An external antenna may be required.
The tuning step is not consistent with broadcasts in your country.
e To correct the tuning step, hold down the BAND button for more than 4 seconds.
Though the broadcast is stereo, it sounds monaural.
e Press the FM MODE button.
Remote control does not work.
e If the batteries are exhausted, change the batteries.
e Use remote control unit within the range (5m/15ft) and point at the front panel.
e Clear obstacles between the remote control unit and the main unit.
e If a fluorescent light is near the unit, turn it off.
If normal operation cannot be achieved, unplug the power cord from the outlet and plug it again.
70
Troubleshooting
ENGLISH