ASSEMBLY INSTRUCTIONS: RSP CONIC
To mount the device on the machine you need an encoder, a total of 2 screws and an Allen
wrench of 3mm. The encoder and screws are supplied by RSP.
RSP CONIC / RSP CONIC PRO. CONIC PULLEY
1.
Approach the encoder to the machine, making sure
that the screw holes and the projection of the encoder
coincide with those of the RSP Conic machine, once it is
coupled and stable, insert and screw the screws with an
Allen wrench.
Screws only secure, do not over tighten.
x1
Allen wrench 3mm
(no supplied)
2.
End view of the encoder coupled to the machine
RSP CONIC. Conic Pulley
x2
27