Programming Clock/Day; Set Point - Pentair STA-RITE CPS 10 Serie Manual De Instrucciones

EN

5.3.1 PROGRAMMING CLOCK/DAY

NOTE
During the first installation phase, the module display flashes to indicate the internal clock needs updating.
NOTE
The clock is equipped with a battery to maintain the time and date for 24 hours if there is no power.
DESCR
MENU
DISPLAY
ORA
PROG. TIME
GIO
To modify the time, repeatedly press the "MODE" button until you arrive to the time parameter.
•
Press the "SET" button to enter the
menu to change the date and hour
•
During the modification of the
parameters, the symbol
display lights up
•
With the buttons it is possible to
modify the time

5.3.2 SET POINT

DESCR
MENU
DISPLAY
SET 1
SET POINT
SET 2
To access this menu press and release the SET button:
•
During the modification of the set
point parameters, the symbol
lights up on the display
•
With the buttons it is possible to
modify the pressure values
NOTE
Press the MODE button to go from SET1 (Set-point1) to SET2 (Set-point2).
Pres "SET" to confirm. The symbol
has been saved. If two SET POINTS are present, it is possible to select the one desired using the "S.P." external contact (see electrical
connections diagram) or the internal clock (see Chapter 5.3).
30
PARAMETER
NAME
Time
Day of week
•
Press MODE to move onto changing
the day
•
With the buttons it is possible to
modify the day
on the
PARAMETER
NAME
Set Point 1
Set Point 2
•
SET POINT 1: Pressure desired by
the system, the module varies the
motor speed to maintain the system
pressure as near as possible to the
set one. During the regulation of this
parameter, "SET 1" appears
will disappear. The words "REC" will appear on the screen for a few seconds to show that the data
DESCRIPTION
Time on system
Day of week
DESCRIPTION
Main pressure value
Secondary pressure value
(can be set only if the parameter SET n = 2)
DEF MIN
00:00 00:00
MO MO
•
To save the values press "SET". The
symbol will disappear and the
words "REC" will appear on the screen
for a few seconds to show that the data
has been saved
•
Press "MODE" to go back to the
pressure screen
DEF MIN
(bar) (bar)
3 1
2 1
•
SET POINT 2: Present only if the
module was set to function with two
set points (SETn = 2", see "ADVANCED
PARAMETERS"). When setting this
parameter the display shows SET1
followed by SET2, proceed to program
MAX
23:59
SU
MAX
(bar)
8
8