Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVE SPARE TIRE
Using a lug wrench remove your spare
tire. Set aside the lug nuts and spare tire.
INSTALL MOUNTING PLATE
Place the mounting plate
onto your spare tire holder.
Adapter plate removal
Using different tongues
In order to fit the range of tire and wheel widths we have included three different
tongue lengths. In order to select which length to try first please see below.
Some wheel offsets may require you to use a different length
tongue than described above. If you cannot tighten the SpareRide
adequately then use a shorter tongue. If you can see the tick mark
on the tongue use a longer tongue (See Step 5).
Instruction #1035694B - Page 2 of 18
Mounting plate rotation
Different vehicles will require different mounting plate
orientations. The two acceptable positions are shown below.
Five or Six threaded studs
Use the numbers on the mounting plate to guide you.
5 = five hole wheel 6 = six hole wheel
Tire
If there is a tire support bracket on
Support
your spare tire mount you will need
Bracket
to remove the adapter plate.
Pull the bottom of the adapter plate
away and down to remove it from
the mounting plate.
Tire Width (Look on the tire sidewall for tire size.)
P195 - P235: Use short Tongue (Pre-Installed)
P235 - P275: Use Medium Tongue
P285 - 12.5": Use Long Tongue
Publicidad
