Zibro SRE 446 E Instrucciones De Uso página 69

G: The required
temperature on the
left, the measured
temperature on the right.
In case of any
malfunctioning the
information display
will tell you what is the
matter.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the
lighter. Just press the
The button will start blinking, indicating that the ignition procedure has started.
This will take a short while. Once the heater is burning, the
lit (red). The information display L will show two numbers (Fig. G). The actual
room temperature is indicated below ROOM, while the temperature setting is
indicated below SET. The latter can be changed with the adjustment keys (refer to
Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use
the adjustment keys O to adjust the temperature. First press either of the two
keys to switch on the function (the °C mark and 4-digit L will start blinking). Next,
adjust the temperature using the key (Mmin.) to set the temperature to a higher
setting and the key (Nhour) to lower the temperature. Press once to increase the
value one step. After approximately 10 seconds the °C mark and 4-digit will stop
blinking and the setting will be locked (Fig. F).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged for more than 10 minutes (or after a power
failure), the temperature will reset to the factory setting of 20°C.
F
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1 Press the button M. The information display will show the CLOCK signal.
Within approximately one minute the flame will have extinguished.
2 Press the TIMER key P, when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
G
THE INFORMATION DISPLAY
The information display L not only serves as an indicator of the (set) time and
temperature (Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE INFORMATION
e - 0
Temperature within the heater too high.
f - 0 Power interrupted.
e - 1
Faulty thermostat.
f - 1 Faulty burner thermistor.
button M. Never use matches or a cigarette
button M to ignite the heater.
button M will remain
WHAT TO DO
Cool-down and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
4
79