Childproof Lock - Zibro SRE 446 E Instrucciones De Uso

H: When the mark
appears, the childproof
lock has been activated.
I: When the SAVE
function is activated, the
heater will automatically
switch on or off in
order to remain within
a specified temperature
range.
J: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
K: A blinking
indicator light is a sign
that you need extra
ventilation.
H

CHILDPROOF LOCK

The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key N and holding
it down for more than 3 seconds. The KEY-LOCK indicator (
information display (Fig. H), indicating that the childproof lock has been activated.
Switch off the childproof lock by pressing the key N and holding it down for more
than 3 seconds once again.
I
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate Q key.
information display (Fig. I). Switch off the function by pressing the SAVE key once again.
Without the 'SAVE' setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
J
THE 'FUEL' INDICATOR
When the FUEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display L (Fig. J). Now you have two options:
e
you remove the fuel tank and refill it outside the living room (section B) or
e
you push the button extension S. By pushing this button, the remaining
heating time will extend to 60 minutes.
The heater will automatically switch back to its lowest position. In the display
the number 60 will appear, which will decline to 10. At the arrival of 10,
you will hear an alarm signal every two minutes, warning you to refill the
removable tank. If you do not react, the heater will extinguish by itself. The
heater will also sound a warning signal, when it switches off. The fuel
indicator will blink, while four lines (--:--) are blinking in the information
display. You can stop this by pressing the
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
K
THE 'VENT' INDICATOR
When there is insufficient ventilation in the room, an intermittent buzzer will
be heard (approximately once each 30 seconds) and the VENT indicator
be blinking. When this signal is given, ensure that the ventilation of the room is
improved (e.g. by opening a door or window a little more), to avoid that the heater
shuts off. When the ventilation of the room is improved, the VENT indicator and
buzzer will be deactivated. When there is still insufficient ventilation, the heater
) will appear on the
will display on the
button M once more.
4
81
will