Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MODE SETTING
Disconnect power before setting the DIP switches; all parts carry dangerous voltages
(mains) !
Remove the front panel and set the DIP switches to select the desired setting.
1
Switch 1:
ON
When choosing 1...10V, input voltages lower than +/- 1V have no influence and the light bulb does not light.
OFF
This setting allows you to choose the control voltage range, i.e. 0...10V. The light bulb starts burning at an input
voltage of a few tenths of mVs and reaches its maximum brightness at 10V.
Switch 2:
This switch allows you to select the delay at which the light bulb reaches its maximum brightness when modifying the control
voltage.
OFF
The bulb's brightness changes immediately upon adjusting the control voltage.
ON
The dimmer will gradually change the brightness towards the newly set brightness level.
Maximum delay 5 sec (0
2
100%).
Mode
7
Publicidad
Tabla de contenido
