Automatic Switch-Off; Maintenance And Cleaning - Imetec M5001 Instrucciones De Uso

• Take a thin lock of hair, the same width as the plate and place it between
the two plates.
• Keep the lock of hair taut with one hand and, with the other hand, slide
the closed plate from the roots down to the ends.
EN
• If you wish to change the hair type selected, press back (4) once and
repeat the selection operations described.
• If you wish to select the manual mode press back (4) twice and follow the
indications in the INSTRUCTIONS FOR USE paragraph; manual mode.
Switching off the product
• Press (Off/On/Confirm) (6) for at least two seconds to switch the product off.
• Disconnect the straightener from the socket.
NOTE: If the straightener is switched off but is not disconnected
from the socket, the background colour of the display remains on
until a temperature of about 70°C has been reached; this indicates
that the straightener is still hot.
Plate closing system
• The straightener has a closing system
• To fasten the two arms in the closed position, hold them together and
press the plates lock (7)
• To unlock, press the plates lock on the opposite side
humidity in the hair evaporating.
magenta the straightener has a fault. Contact an assistance centre.

AUTOMATIC SWITCH-OFF

The straightener switches off automatically 1 hour after being switched on.
o n .
• Switch off the appliance by pressing (Off/On/Confirm) (6) for at
least two seconds and disconnect the plug (8) from the socket
3166_M5001_.indd 16
NOTE: steam may appear while straightening; this is excess
NOTE: If the background colour of the display flashes red or
ATTENTION! Risk of scalding

MAINTENANCE AND CLEANING

WARNING! Always disconnect the
appliance from the socket
cleaning or performing maintenance.
WARNING! Make sure all cleaned parts
are completely dry before reusing the
appliance.
16
before
06/06/18 11