Pioneer CT-F10 Manual De Instrucciones Suplementario página 4

Grabadora de casete estéreo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Thank you for buying this
Pioneer product.
Please read through these operating instructions
so you will know how to operate your model
properly. After you have finished reading the
instructions, put them away in a safe place or
future reference.
In some countries or regions, the shape of the
power plug and power outlet may differ from that
shown in the explanatory drawings. However, the
method of connecting and operating the unit is
the same.
• This component cannot be operated alone;
please use in combination with the CD Tuner
System XC-F10 and Power Amplifier M-F10.
These supplementary operating instructions
contain information relating to connections and
specifications for the Pioneer stereo cassette deck
CT–F10.
For information on cassette tape maintenance,
actual operating procedures, and troubleshooting
regarding this component consult the main
Operating Instructions included with the CD Tuner
System (sold separately).
Connecting the cassette deck
to the CD tuner or optional
CD recorder
Connect this cassette deck to the CD-tuner or
optional CD recorder as described below.
• Important: When connecting or disconnecting
the system cable, make sure that the power is
switched off and the unit unplugged from the
wall outlet.
4
En
1 Thread the system cable through
Stand A, then slot the stand on to
the rear side of the unit.
Line up the three tabs on the Stand A with the
holes on the CD-tuner (or CD-Recorder), then
slot it into place.
Stand A
2 Connect the other end of the
ribbon cable to the CD-tuner unit
or to your optional CD-Recorder.
It's much easier to connect the ribbon cable if
Stand A is not attached. However, remember
that the cables must be threaded through the
stand for it to be attached. The following
illustration is for the CD-tuner set up only. For
the optional CD-Recorder, the ribbon cable
will be attached in the same manner, and the
ribbon cable from your CD-Recorder will link
the connection to the main unit.
If you have the optional cassette deck or CD-
Recorder, connect these before attaching
Stand A. (The ribbon cable can pass under the
Stand A to keep it tidy.)
CD-tuner
XC-F10
Stand A

Publicidad

Tabla de contenido
loading

Tabla de contenido