Publicidad
Idiomas disponibles
Idiomas disponibles
DSH-FS floor saw cart assembly instructions
1. Safety precautions
G
Use this floor saw cart only in conjunction with the Hilti DSH 700 or DSH 900 gas
saws.
en
G
Observe the instructions and safety precautions listed in the operating instruc-
tions for your Hilti gas saw.
2. Assembling the floor saw cart
2.1 Fitting the handle
2
Fit the handle
to the frame
2.2 Fitting the wheel axle to the frame
Push the wheel axle
into the holes in the frame
knob
.
2.3 Fitting the second wheel
Secure the second wheel
pin
.
2.4 Fitting the front wheel
Fit the front wheel
to the front wheel axle
and split pin
.
2.5 Fitting the spray guard
Use the two the screws
to secure the spray guard
3. Adjusting the machine mount
G
Note: The machine mount is set in such a way that the saw arm of the DSH 900-
40 gas saw does not come into contact with the floor when cutting to full depth.
When used with the DSH 900-35, DSH 700-35 and DSH 700-30, the machine
mount must be fitted in a lower position in order to reach full cutting depth.
3.1 Disassembling the machine mount
Remove both hex. nuts
and screws
3.2 Fitting the machine mount in the lower position
Insert the two screws
in the upper openings in the machine mount
the machine mount to the frame
G
Note: When fitting the machine mount, take care to ensure it is aligned centrally.
2
3
and secure it with the screw knob
4
and secure it with the screw
5
6
7
on the wheel axle
by fitting the washer
8
9
and secure it with the washer
10
11
to the frame
12
13
from the machine mount
14
15
once again.
4. Adjusting for straight running
G
Note: The floor saw cart is designed so that the gas saw cuts in a straight line
when the mark on the machine mount is in the middle position. If it is found that
the gas saw pulls to one side while cutting, this can be compensated by adjust-
ing the position of the machine mount.
4.1 Adjusting the machine mount
Release the upper hex. nut
machine mount toward the side to which the saw tends to pull when cutting.
.
5. Fitting the gas saw
1. Bring the height adjustment lever
2. Release the screw knob
3. Place the gas saw in the forward section of the machine mount with its wheels
positioned as shown in the illustration and then pivot the grip of the saw
the grip clamp
and split
4. Secure the gas saw by tightening the screw knob
5. Fit the water container
6. Adjust the position of the handle to bring it into a comfortable working position.
7. Adjust the disc/blade guard.
.
.
16
and secure
17
for straight running
on the machine mount
to
18
26
into the upper position.
on the grip clamp
.
U
.
.
after filling it.
and pivot the rear of the
Z
into
Publicidad
