Fermax BUS2 Manual De Instalador página 7

OPERATION
* Setup:
To turn on the verifier, hold down the key
The display shows the following message MOD (main menu).
* Navigate through the menu:
Once in the main menu use the following keys
· Aut : Automatic Verifier Mode
· SPY : Spy Mode
· PnL : Auxiliary Panel Mode
* Select function:
When the display shows the chosen option, press
The green «OK» led lights up to confirm that the option has been selected.
Pressing the following key
Pressing the following key
Automatic Mode (AUT)
In automatic mode «AUT» the BUS 2 system verifies the telephone's/monitor's data status.
To this end, the verifier sends a test command to the range of telephone/monitor addresses selected and
awaits a response from each address. This means that:
• If the telephone/monitor is off, this address will show up as an error.
• If there are two telephones/monitors with the same address it will only give an error message if both
telephones/monitors do not respond.
• If there is one address within a range that is not programmed there will be no answer and an error will
be reflected.
AUT Operating Mode:
- Select AUT mode and press the following key
The display shows the letter A indicating that the first address must be entered.
- Press the following keys
- Press the key to confirm.
The display shows the letter b indicating that the final address must be entered.
- Press the following keys
- Press the key to confirm.
The verifier automatically verifies all the addresses from A to b, inclusive.
When the test is finished, the display will show the first address and you can navigate through the rest of
the addresses tested using the keys
For each address the red and green leds indicate if the test is correct or incorrect.
If the key is pressed for an address, a call is made to the telephone/monitor with this address to verify
.
the result
for more than 5 seconds.
whilst in either of these options brings you back to the previous option.
whilst in the main menu MOD causes the verifier to switch off.
.
to select the first address from the range of addresses to be verified.
and to select the final address
.
ENGLISH
to navigate through the various available functions:
Pag 7